Household Photovoltaic Solar Float Valve Installation Instructions

How to install a solar photovoltaic system?

The installer should conform to all the safety precautions listed in this guide when installing the module. Local codes should also be followed in such installations. Before installing a solar photovoltaic system, the installer should become familiar with the mechanical and electrical requirement for such a system.

How to maintain a solar PV system?

Observe the maintenance instructions for all components used in the system, such as support frames, charging regulators, inverters, batteries, etc. Removing the bypass diodes should be done only by a competent PV technician and after the module has been disconnected from the system.

Who should install a solar photovoltaic system?

Installation should only be performed by qualified personnel. Before installing a solar photovoltaic system, installers should familiarize themselves with its mechanical and electrical requirements. Keep this guide in a safe place for future reference and in case of sale or disposal of the Modules.

How do you wire a solar PV system?

Use field wiring with suitable cross-sectional areas that are approved for use at the maximum short-circuit current of the Modules. JA Solar recommends installers use only sunlight resistant cables qualified for direct current (DC) wiring in PV systems. And the rated system voltage of PV wire should be not than PV modules.

What is included in the JA Solar Module installation manual?

Thank you for choosing JA SOALR Modules! This Installation Manual contains essential information for electrical and mechanical installation that you should know before handling, installing JA Solar Modules. This Manual also contains safety information you need to be familiar with.

How do you mount a solar module?

The most common mounting is achieved by mounting the module using the four symmetry points close to the inner side on module frame. Refer to the following picture for more details. Note that the holes in the center (blue) are for grounding. Modules should be safely fixed to bear all expected loads, including wind and snow loads.