Solar one-way valve installation diagram

How does a three-way valve work on a solar pool?

In most cases your plumbing will be similar to the plumbing shown. Notice that the first Check Valve is plumbed in after the filter. This prevents the filter from being back-washed by the water draining from the panels when the pump shuts off. The Three-way Valve either diverts the water to the solar system or directly back to the pool.

How do I install a hot water valve?

Connect a pipe from the Cold water supply to the cold water side of the valve. Connect a pipe from the Hot water out let to the hot side of the valve. Complete the piping for the bottom (outlet) of the valve to the piping for the hot taps. NB.: some Tempering valves can be set to different temperature we recommend keeping the valve set to 55°C. 1.

How do you mount a solar controller?

Mount the controller vertically using the mounting plate supplied, in a ventilated area out of direct sunlight. This is often half way up the array post under the panels. The controller should be placed at a good working height, shaded by the panels and protected from contact by livestock, wild animals or children.

How do I install a T/P valve?

h. Install the T/P valve in the Geyser outlet facing away for the system. Note: Before completing the connections make sure all the tubing is lagged, both inside and outside the roof. Once all the connections are complete and correct you can open the Gate valve to allow the system to fill. Please inspect the entire installation for any leaks. 7.

How do you drain a solar system?

When this is completed drain the solar loop using the System Drain Valve below the pump (On DBSA systems the System Drain Valve is behind the shroud). When the tank is fully drained use a hose to continue flushing out the drainback tank for 5 minutes. Turn off the hose and let the system drain fully.

How do you attach a solar collector to a roof?

AND ARE DESIGNATED IN INCHES The most important structural consideration is to securely anchor the solar collector and the Solar Strut mounting hardware to the structural members of the roof with stainless steel hanger or lag bolts. The solar collector must be attached to the mounting hardware as detailed in Figures 5-12.